Save these instructions, Refueling precautions, Basic specifications – Harbor Freight Tools GREYHOUND 97964 User Manual
Page 6: Unpacking, Set up instructions
Page 6
SKU 97964
For technical questions, please call 1-800-444-3353.
Store the Engine out of the reach of
7.
children.
Follow scheduled engine mainte-
8.
nance.
REFuELING PREcAuTIONS:
Do not smoke, or allow sparks,
1.
flames, or other sources of ignition
around the Engine, especially when
refuelling.
Do not refill the fuel tank while the
2.
Engine is running or hot.
Do not fill fuel tank to the top. Leave
3.
a little room for the fuel to expand as
needed.
Refuel in a well-ventilated area only.
4.
SAVE THESE
INSTRucTIONS.
BASIc SPEcIFIcATIONS
Fuel
Type
89+ octane unleaded
gasoline
Capacity
.42 Gal. (1.4 liters)
Engine Oil
Type
SAE 30W
(above 32° F)
SAE 5W-30
(at 32° F or below)
Capacity
13.5 Oz. (0.4 liters)
Note: Additional specifications found in
the TECHNICAL ENGINE SPECIFI-
CATIONS chart in this manual.
The emission control system for this
engine is warranted for standards set by
the U.S. Environmental Protection Agency
and by the California Air Resources Board
(also known as CARB). For warranty
information, refer to the last pages of this
manual.
At high altitudes, the Engine’s car-
buretor, governor and any other parts that
control the fuel-air ratio will need to be
adjusted by a qualified mechanic to allow
efficient high-altitude use and to prevent
damage to the Engine and any other de-
vices used with this product.
uNPAcKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
SET uP INSTRucTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOuS INjuRY
FROM AccIdENTAL
STARTING:
Turn the Power Switch of the
equipment to its “OFF”
position, wait for the engine to
cool, and disconnect the
spark plug wire(s) before
assembling or making any
adjustments to the equipment.
TO PREVENT
SERIOuS INjuRY:
Operate only with proper
spark arrestor installed.
REV 08e