Harbor Freight Tools GREYHOUND 97964 - Manual (Page 5)

Page 5 SKU 97964 For technical questions, please call 1-800-444-3353.
Keep the Engine and surrounding 13.
area clean at all times.
Use the Engine in accordance with
14.
these instructions and in the man-
ner intended for the particular type
of Engine, taking into account the
working conditions and the work to be
performed. Use of the Engine for op-
erations different from those intended
could result in a hazardous situation.
Do not operate the Engine with
15.
known leaks in the Engine’s fuel
system.
This product contains or, when used,
16.
produces a chemical known to the
State of California to cause cancer
and birth defects or other reproduc-
tive harm. (California Health & Safety
Code § 25249.5, et seq.)
When spills of fuel or oil occur, they
17.
must be cleaned up immediately.
Dispose of fluids and cleaning materi-
als as per any local, state, or federal
codes and regulations. Store oil rags
in a bottom-ventilated, covered, metal
container.
Keep hands and feet away from
18.
moving parts. Do not reach over or
across the Engine while operating.
Before use, check for misalignment
19.
or binding of moving parts, breakage
of parts, and any other condition that
may affect the Engine’s operation.
If damaged, have the Engine ser-
viced before using. Many accidents
are caused by poorly maintained
engines.
Use the correct Engine for the appli-
20.
cation. Do not modify the Engine and
do not use the Engine for a purpose
for which it is not intended.
SERVIcE PREcAuTIONS
Before service, maintenance, or 1.
cleaning:
Turn the Power Switch (94) to its a.
“OFF” position.
Allow the Engine to completely
b.
cool.
Then, remove the Spark Plug wire
c.
from the Spark Plug.
Keep all safety guards in place and in 2.
proper working order. Safety guards
include Muffler, Air Cleaner, mechani-
cal guards, and heat shields, among
other guards.
do not alter or adjust any part of
3.
the Engine that is sealed by the
manufacturer or distributor. Only
a qualified service technician may
adjust parts that may increase or
decrease governed Engine speed.
Wear ANSI-approved safety goggles,
4.
heavy-duty work gloves, and dust
mask/respirator during service.
Maintain labels and nameplates on
5.
the Engine. These carry important
information. If unreadable or miss-
ing, contact Harbor Freight Tools for a
replacement.
Have the Engine serviced by a quali-
6.
fied repair person using only iden-
tical replacement parts. This will
ensure that the safety of the Engine
is maintained. Do not attempt any
service or maintenance procedures
not explained in this manual or any
procedures that you are uncertain
about your ability to perform safely or
correctly.