haier HWM6802 - Manual (Page 8)

10
Use the operation buttons
The user selects a suitable water level
depending on the load.
" WATER LEVEL"button
a. Description of the function of the buttons
POWER
ON/OFF
START
PAUSE
PROGRAM RESERVE WATER
LEVEL
SOAK
WASH
RINSE
SPIN
INDICATION OF PROCESS
(NO CHOOSING)
PROGRAM
HEAVY
SOFT
SAVE
SINGLE WASH
TUB CLEAN
STANDARD
"PROGRAM/ " button RESERVE
you can select one or several of
,Heavy,Soft
and Tub clean
Press
programs
.
"PROGRAM/RESERVE " button
Standard ,Save,Single wash
you can select
of peservtion.
Press
over 2 seconds,
the program
the N tube displays the
reserved hours to the wash cycle end. The
indicator flashes to indicate in-reservation.
"PROGRAM/RESERVE " button
ixie
Remarks: After pressing "POWER ON/OFF" to connect power supply, if the washing machine
lasts idle more than 5 min, it would automatically shut off the supply.
After the power is switched on, press it to
start the machine
During working, push it to pause working.
During pause, push this button to restart
and continue operation.
"START/PAUSE"button
Press "Power On/Off" button to connect
power supply.
After power is connected, pressing this
button will cut off the supply.
"POWER ON/OFF"button
7
1.Do not take off the water absorption
cushion. Please check if the cushion
is dropped or damaged before each
usage. If it happens please contact
our after-sale department immediately.
2.Put the nut of the water inlet hose on
the valve jointer.
3.Fasten the nut. Swaying it gently to
confirm if it's suitable.
1.Close the water tap.
2.Press the locking lever. Push down the slider. Then
pull off the water inlet hose. If the machine is used
more than once every week, the jointer of the water
inlet hose can be kept on the tap to prevent
damaging the fixing screw.
1.Push down the slider. Insert the
water inlet hose into the jointer.
2.Hang the lock lever to the jointer.
Release the slider till a click
sound is heard.
Locking lever
Slider
Water absorption cushion
Nut of the water inlet hose
Jointer of the water inlet valve
Slider
Jointer of the water
inlet hose
Locking lever
Connection between the water inlet hose and the
washing machine
Connection between the jointer of the water inlet
hose and the water inlet hose
Check the connection between the jointer of the
water inlet hose and the water tap
Take down the water inlet hose
1.Swaying the hose gently to confirm if it is fastened
stable.
2.After installation, open the tap to check if it leaks.
3.Do not bend the hose with overstrain.
4.Before each usage please check if
the connection between the jointer
of the water inlet hose and the water
tap, and the installation of the
water inlet hose are firm, so as to
prevent dropping from improper
Indicator mode and meaning
Flashing: indicate the running program
On: indicate the program about to run, or
indicate the selected mode
Off: