haier HWM6802 - Manual (Page 6)

4
Installation and adjustment
The largest allowed slope of the
shank base of the machine is 2
.
The slanting or rough ground will
result in unstable running or
stoppage of the machine. Please
adjust it with following methods:
Adjust the adjustable foot:
Install the bottom plate
After you open the package, please lean the washing machine gently down
on soft items ( like the towel cloth,blanket, etc. ). Install the bottom plate to
the bottom of themachine with the screws by a crossscrewdriver,
then lift the machine up gently.See to the figure:
Adjust the installation position
Please install and adjust the machine according to the requirement of the manual. It is
very important to your security and correct operating the machine.
1.To twist the adjustable foot, please
first lift up the side of the foot slightly,
loosen the adjustable nut, and twist
the foot.
2.Fasten the nut after adjustment.
Loosen Fasten
High Low
adjustable nut
adjustable foot
Back
Front
Bottom plate
Screw
Soft items
13
After switching on, the washing machine reserved wash program will be automatically set
inactive. If you desire a wash cycle to end at a reserved time, you can press the
" " button over 2 seconds to set a reserved wash program.
Refer to The button of " " on page 10.
PROGRAM/RESERVE
PROGRAM/RESERVE
When " Reserve " becomes active, the nixie tube
displays the time to the end of the reserved wash cycle, and
the indicator turns on.
To change the running program or cancel the reservation,
you should cut off the supply and reselect.
the washing will finish
about 18 hours later
Confirm the reserve program
START
PAUSE 5 Press the "start/pa use" button
4 Push the " " button
to select suitable reserve program
PROGRA M/RESERVE
Close the top lid
Finish washing
During spinning, if the top cover is opened, the washing machine will stop running
and alarm
The washing machine cuts off the power supply
automatically when wash cycle ends.
After switching on the power, press the button "WATER LEVEL" to select a water level according
to the load. Please refer to the button " Water level" on page 10.
Page 10
3 Press the "WATER LEVEL" button to select suitable
water level
WATER LEVEL
START
PAUSE
PROGRAM
RESERVE
Page 10