Hotpoint FEW10 - Manual (Page 5)

2
CONNECT TO THE COLD
WATER SUPPLY...
The Dispenser Drawer STEP 3
ii i
Index:
1. Drawer release latch
2. Pre-wash detergent compartment
Maximum 200ml powder or
100ml liquid
3. Main detergent compartment
Maximum 400ml powder or
200ml liquid
4. Grate
5. Fabric conditioner compartment
120ml maximum
1
2
3
4
5
PLEASE USE THE NEW HOSE SUPPLIED, FITTED
TO THE MACHINE.
Old hoses may
cause leaks due to
worn out washers.
Check the cold
water supply is
running freely... Connect fill hose (Blue
connector) to the cold
water supply tap.
TURN COLD WATER
SUPPLY TAP ON...
DO NOT REMOVE!
Y
to the
nage
sing a
...
PARTS OF THE INSTALLATION AND TO THOROUGHLY
SIDE OF YOUR MACHINE:
MME ‘C’ (refer to ‘Programme Selector Dial’, STEP 4).
WITHOUT ANY LAUNDRY
WITHOUT ANY DETERGENT
and
KE APPROXIMATELY 2hours 30minutes TO COMPLETE
✗
WARNING:
● Do not put any items into
the drawer, other than
detergents designed to be
released from the drawer, as
they may cause damage or
blockage.
Adding Fabric Conditioner
Dispensing Powder Detergent
Dispensing Liquid Detergent
To achieve the best wash results the manufacturer’s
recommended amount of detergent should be measured
and added to the main detergent compartment (II symbol)
(max. 400ml).
Pour the recommended amount of fabric conditioner into the
compartment (flower symbol).
Do not exceed the maximum fill line.
Pre-wash Programmes A and B
When selecting programmes A or B add detergent to both the pre-wash
compartment (I symbol) and the main wash compartment (II symbol).
DO NOT use in drum dosing devices with Pre-wash programmes A and B.
We recommend the use of a detergent dosing ball, as provided by your
detergent manufacturer.