Harbor Freight Tools 47996 - Manual (Page 2)

Page 2 SKU 47996
Specifications
ITEM DESCRIPTION
Welding Protection Types
For MIC / MAG, Flux Cored, TIC, Plasma /
Microplasma Arc
Not Protected From Laser welding and oxyhydrogen welding
Filter Standard ANSI Z87.1 -- 1989 (R1998) Standard
Switch On / Off to use power from internal batteries; auto-off
Construction
High impact resistant plastic polyamide nylon;
Full Face; Retainer and ratchet headband
Darkness Range
Shade Control: Clear state # 3; Dark: DIN 4, 9 ~ 13
adjustable
Lens Protection Ultraviolet and infrared
Lens Viewing Size 3.5 (W) x 1.5 (H) inches
Lens Switching Speed 1/1000 second (to dark); 1/2 second (to light)
Lens Shade Green
Filter Overall Size 4.75 (W) x 3-1/2 (H) x 5/8 (D) inches
Power Source Solar powered with two AAA backup batteries
Operating Temperature 23° ~ 131° F; (- 5° ~ 55° C)
Weight 1.15 lbs.
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
WARNING: When using tool, basic safety precautions should always be followed to re-
duce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
1. Do not attempt to use the Auto Darkening Welding Helmet if the Lens has been
damaged in any way. Severe eye damage will occur.
2. Keep work area clean. Cluttered areas invite injuries.
3. Observe work area conditions. Do not use machines or power tools in damp or wet
locations. Don’t expose to rain. Keep work area well lighted. Do not use electrically
powered tools in the presence of flammable gases or liquids.
4. Keep children away. Children must never be allowed in the work area. Do not let them
handle machines, tools, or extension cords.
5. Store idle equipment. When not in use, tools must be stored in a dry location to inhibit
rust. Always lock up tools and keep out of reach of children.
6. Use the right tool for the job. Do not attempt to force a small tool or attachment to do
the work of a larger industrial tool. There are certain applications for which this tool was
For MIG / MAG, Flux Cored, TIG, Plasma /
Microplasma Arc
REV 05/05