Harbor Freight Tools 47158 - Manual (Page 11)

Page 11 SKU 47158 For technical questions, please call 1-800-444-3353.
INSPECTION, MAINTENANCE, AND CLEANING
NOTE: For additional references to the parts listed below, refer to the Assembly
Diagram on page 14.
1. CAUTION: Always unplug the Power Cord/Plug (part #18) from its 10 volt elec-
trical outlet before performing any inspection, maintenance, or cleaning.
. BEFORE EACH USE, inspect the general condition of the Micro Mill/Drill Ma-
chine. Check for loose screws, misalignment or binding of moving parts, cracked
or broken parts, damaged electrical wiring, and any other condition that may
affect its safe operation. If abnormal noise or vibration occurs, have the problem
corrected before further use.
Do not use damaged equipment.
3. DAILY: With a soft brush, cloth, or vacuum, remove all debris from the Micro Mill/
Drill Machine. Then, use a premium quality, lightweight machine oil to lubricate all
moving parts.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND
ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE
MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY
OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS
TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF
THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF
HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.