Harbor Freight Tools 97563 User Manual

Page 5

Page 5

SKU 97563

For technical questions, please call 1-800-444-3353.

one on each side, and six Nuts (5). Hand tighten the Nuts (5) initially (see

Fig-

ures 1 and 2).

Bolt

Upright Post

Long Rod

Short Rod

Flat Washer

Nut

Safety Pin

Figure 2

Repeat step 1 to assemble the second Upright Post set.
Using two persons, stand up the two Upright Post assemblies in position and at-

tach one Cross Beam (6) into the second Slot from the bottom of the two Upright

Posts. These Cross Beams (6) have two metal Tabs on each end which slip into

the Slots of the Upright Posts (2). Make sure the Flange on the Cross Beam (6)

is facing up. This Flange will hold the Steel Shelves (7) in place (See Figure 1).
Repeat step 4 with a Cross Beam (6) on opposite side of Upright Post assembly.
Only one person is needed to finish the assembly. Continue to attach Cross

Beams (6) (Flanges pointing upward) at desired heights. The Cross Beams (6)

on the top level must be positioned at the top Slot of the Upright Posts (2). Make

sure each Cross Beam (6) is located in same Slots as the Cross Beam directly

opposite its height on the Upright Post (2). This is to ensure that wneh the

shelves are inserted, they will lay flat.
Use a rubber mallet (not supplied) to drive the Wedge at both edges of the Cross

Beams (6) into the Slots on the Upright Posts (2) as deep as possible. Strike the

Cross Beam (6) with the mallet as close to the Upright Post (2) as you can.

3.
4.

5.
6.

note:

Foot Plate at

base of uprights

must rest on the

floor.