Hitachi DH 30PC2 - Manual (Page 8)

7
English
Anchor setting adapter (for manual hammer)
Anchor setting adapter
(for manual hammer)
Anchor setting adapter (SDS-plus shank)
(for rotary hammer)
Overall length: 160, 260 mm
Anchor size
W1/4"
W5/16"
W3/8"
Anchor size
W1/4"
W5/16"
W3/8"
W1/2"
W5/8"
3. Large hole boring (rotation + hammering)
Center pin, core bit, core bit shank and guide plate.
(Guide plate) Center pin Core bit Core bit shank
(SDS-plus shank)
Center pin Core bit (outer diameter) Core bit shank
–
25 mm
29 mm
(A)
32 mm Core bit shank (A)
Center pin (A) 35 mm
38 mm
45 mm
50 mm
Center pin (B) (B) 65 mm Core bit shank (B)
80 mm
90 mm
Do not use core bits with with guide plate
outer diameter of 25 mm (The guide plate is not equipped with core bits
and 29 mm. with outer diameter of 25 mm and 29 mm.)
2. Anchor setting (hammering only)
Anchor setting adapter (for rotary hammer)
4. Demolishing operation (hammering only)
Bull point (Round type) (SDS-plus shank)
Bull point (Square type) (SDS-plus shank)