Horizon Fitness PERFORMANCE T1200 - Manual (Page 5)

BEFORE
YOU
BEGIN
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
TREADMILL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
TREADMILL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
A Open HARDWARE BAG 1.
B Slide LEFT CONSOLE MAST over
MAIN FRAME BRACKET.
C Insert 2 BOLTS (A) on the bottom
outside of the mast and secure with
2 FLAT WASHERS (B) and
2 NUTS (C).
D Insert BOLT (D) with ARC WASHER
(E) into front hole on the mast and
completely tighten.
E Use flat wrench to completely
tighten NUTS (C) inserted in Step C.
Disassemble box and remove the cardboard packaging that is not beneath the treadmill. Do not attempt to
lift the treadmill at this time. Remove plastic wrap from console masts.
*NOTE:
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in
before completely tightening any ONE bolt. A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
PRE-ASSEMBLY
MAIN FRAME BRACKET ARC WASHER (E) BOLT (D) BOLTS (A)
LEFT CONSOLE MAST
NUTS (C) FLAT WASHERS (B)
LEFT CONSOLE MAST
CONSOLE MAST BOOT
ASSEMBLY STEP 1
BOLT (D)
15 mm
Qty: 1
BOLT (A)
60 mm
Qty: 2
FLAT WASHER (B)
8 mm
Qty: 2
NUT (C)
8 mm
Qty: 2
ARC WASHER (E)
6 mm
Qty: 1
HARDWARE BAG 1 CONTENTS :
ASSEMBLY STEP 2
RIGHT CONSOLE MAST
LEAD WIRE
CONSOLE CABLES
MAIN FRAME BRACKET
CONSOLE CABLES
ARC WASHER (E)
BOLT (D)
BOLTS (A) RIGHT CONSOLE MAST
NUTS (C)
FLAT WASHERS (B)
BOLT (D)
15 mm
Qty: 1
BOLT (A)
60 mm
Qty: 2
FLAT WASHER (B)
8 mm
Qty: 2
NUT (C)
8 mm
Qty: 2
ARC WASHER (E)
6 mm
Qty: 1
HARDWARE BAG 2 CONTENTS :
A Pull LEAD WIRE through RIGHT
CONSOLE MAST.
After pulling the lead wire through
the mast, the top of the console
cables should be located at the top
of the mast.
Detach and discard lead wire.
B Open HARDWARE BAG 2.
C Slide RIGHT CONSOLE MAST over
MAIN FRAME BRACKET.
*Note: Do not pinch CONSOLE
CABLES when placing the mast onto
the main frame.
D Insert 2 BOLTS (A) on the bottom
outside of the mast and secure with
2 FLAT WASHERS (B) and 2 NUTS
(C).
E Insert BOLT (D) with ARC WASHER
(E) into front hole on mast and
completely tighten.
F Use flat wrench to completely
tighten NUTS (C) inserted in Step D.
T1200_Treadmill_Rev.1.9.indd 8-9 6/22/07 4:45:02 PM