Harbor Freight Tools CENTRAL PNEUMATIC PROFESSIONAL 94803 - Manual (Page 2)

Page 2 SKU 94803 For technical questions, please call 1-800-444-3353
Specifications
Maximum Torque 425 ft-lb
Drive Size 1 /
2
” Square
Air Inlet 1 /
4
” - 18 NPT
Recommended Air Pressure 90 PSI
BPM 900
Speed 6500 RPM
Average Air Consumption 4 CFM
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
WARNING: When using tool, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
1.
Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Do not use machines or power tools in damp or wet
locations. Don’t expose to rain. Keep work area well lighted. Do not use electrically
powered compressors in the presence of flammable gases or liquids.
3. Keep children away. Children must never be allowed in the work area. Do not let
them handle machines, tools, extension cords, or air hoses.
4. Store idle equipment. When not in use, tools must be stored in a dry location to
inhibit rust. Always lock up tools and keep out of reach of children.
5. Use the right tool for the job. Do not attempt to force a small tool or attachment
to do the work of a larger industrial tool. There are certain applications for which this
tool was designed. It will do the job better and more safely at the rate for which it was
intended. Do not modify this tool and do not use this tool for a purpose for which it
was not intended.
6. Dress properly. Do not wear loose clothing or jewelry as they can be caught in
moving parts. Protective, electrically non-conductive clothes and non-skid footwear
are recommended when working. Wear restrictive hair covering to contain long hair.
7. Use eye and ear protection. Always wear ANSI-approved impact safety
goggles and hearing protection. Wear a full face shield if you are producing
metal filings or wood chips. Wear an ANSI-approved dust mask or respirator
when working around metal, wood, and chemical dusts and mists.