Harbor Freight Tools 65161 - Manual (Page 9)

SKU 65159 60 61 For technical questions, please call 1-800-444-3353. Page 9
desired orientation. Set to Forward by
turning counterclockwise; Reverse by
turning clockwise.
For 65161 3/8” Air Ratchet, turn
Forward/Reverse Lever (42) to the
desired orientation. Set to Forward by
turning counterclockwise; Reverse by
turning clockwise.
To adjust air pressure from Low to
3.
High, use a flat-head screwdriver (not
included) and:
For 65159 1/4” Air Ratchet, turn the
Air Regulator (6) to the desired Low/
High Setting.
For 65160 1/2” Air Ratchet, turn the
Air Regulator (9) to the desired Low/
High Setting.
For 65161 3/8” Air Ratchet, turn the
Air Regulator (7) to the desired Low/
High Setting.
Place the drive socket over the nut to
4.
be tightened or loosened.
For 65159 1/4” Air Ratchet, push the
Trigger (48) down to activate tool.
For 65160 1/2” Air Ratchet, push the
Trigger (14) down to activate tool.
For 65161 3/8” Air Ratchet, push the
Trigger (4) down to activate tool.
When job is done, release Trigger.
5.
If the tool requires more force to 6.
accomplish the task, verify that the
tool receives sufficient, unobstructed
airflow (CFM) and increase the
pressure (PSI) output of the regulator
up to the maximum air pressure
rating of this tool.
CAuTION!
7. TO pREVENT TOOl
ANd ACCESSORY FAIluRE,
RESulTINg IN INjuRY:
do not exceed the tool’s maximum
air pressure rating. If tool still does
not have sufficient force at maximum
pressure and sufficient airflow, then a
larger tool may be required.
To prevent accidents, detach air sup-
8.
ply, safely discharge any residual air
pressure in tool, and release throttle
and/or turn switch to off position after
use. Clean external surfaces of tool
with clean, dry cloth, and apply a thin
coat of tool oil. Then store tool in-
doors out of children’s reach.