Horizon Fitness CLUB S400 - Manual (Page 5)

INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
&
MAINTENANCE
LIMITED
W
ARRANTY
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE YOU
BEGIN
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY STEP 2
NYLON NUT (C)
Qty: 6 FLAT WASHER (B)
Qty: 12 BOLT (A)
Qty: 4
BOLT (D)
Qty: 2 SUPPORT PLATE
Qty: 2
HARDWARE BAG 1 CONTENTS :
LAT BAR
BRACKET ASSEMBLY
UPPER PULLEY ASSEMBLY
FLAT WASHER (B)
NYLON NUT (C)
FLAT WASHER (B)
SUPPORT
PLATE
BOLT (A)
FLAT WASHER (B)
BOLT (D)
FLAT WASHER (B)
NYLON NUT (C)
ASSEMBLY STEP
NYLON NUT (C)
Qty: 2 FLAT WASHER (B)
Qty: 4 BOLT (A)
Qty: 2 SCREW (F)
Qty: 4
HARDWARE BAG 2 CONTENTS :
RADIAL ARM ASSEMBLY
NYLON NUT (C)
FLAT WASHER (B)
FLAT WASHER (B)
BOLT (A)
SEAT WELDMENT SET
FRONT COVER
BACK COVER
SCREW (F)
Open HARDWARE BAG 1.
Attach UPPER PULLEY
ASSEMBLY to CENTER
SUPPORT FRAME using 2
BOLTS (D), 4 FLAT WASHERS
(B) and 2 NYLON NUTS (C).
Tighten this hardware.
Position LAT BAR BRACKET
ASSEMBLY in line with the
UPPER PULLEY ASSEMBLY
and the LEFT SUPPORT
FRAME and RIGHT SUPPORT
FRAME as shown. Using 4
BOLTS (A), 8 FLAT WASHERS
(B) and 4 NYLON NUTS (C)
attach SUPPORT PLATES, LAT
BAR BRACKET ASSEMBLY and
UPPER PULLEY ASSEMBLY to
the LEFT SUPPORT FRAME and
RIGHT SUPPORT FRAME as
shown.
A
B
C
Open HARDWARE BAG 2.
Attach SEAT WELDMENT SET.
Attach COVER to bolted joint using 4 SCREWS (F).
Remove STOPPER from front side of RADIAL ARM ASSEMBLY and reinstall on back side of
RADIAL ARM ASSMBLY.
Attach RADIAL ARM ASSEMBLY to CENTER SUPPORT FRAME using 2 BOLTS (A), 4 FLAT
WASHERS (B) and 2 NYLON NUTS (C).
A
B
C
D
E
RADIAL ARM ASSEMBLY
STOPPER
STEP -D: INSTALLING THE STOPPER:
S400_US_1.1.indd 8-9 8/31/07 10:10:27 AM