Hill Phoenix 05DMA - Manual (Page 9)

5
The O5DMA is shipped with most of
the exterior panels and trim already installed.
The only exterior parts that need to be
installed when the case arrives are the kick-
plate and the end kickplates. If the cases are
equipped with contour front panels the upper
kickplate retainer is also shipped loose with
the case.
The kickplate, which is shipped in the
case, simply slips up and behind the front
panel and then down onto the “J” rail. See
illustration 1 below for details. When
installing the upper kickplate retainer make
sure it is placed behind the front panel lip as
shown in illustration 1 below.
The end kickplates, which are also
shipped in the case, are attached to the
baseframes directly under the ends with the
screws provided. There are two, smoke grey
plug buttons that are inserted into each end
kickplate to cover the screw holes, see illus-
tration 2 below.
1
2
KICKPLATE
F RONT PANEL
“J” RAIL
SCREW
PLUG BUTTON
END KICKPLATE
BASEFRAME
END
KICKPLATE
F RONT PANEL LIP
“J” RAIL
UPPER KICKPLATE
RETAINER
FLAT FRONT PANELS CONTOUR FRONT PANELS
INSTALLATION