beautypg.com

Depth offset, Temp offset – Humminbird 363 User Manual

Page 87

background image

80

To Select Readouts:

1. Make sure you are in Advanced User Mode, then highlight Select Readouts on

the Setup main menu.

2. Use the RIGHT 4-WAY Cursor Control key to initiate this procedure.

3. The Select Readouts submenu will appear, showing a list of all Readouts. Use

the UP or DOWN Cursor keys to select a particular Readout position, then
use the RIGHT or LEFT Cursor keys to change what will be displayed at that
position. (Course, Navigation, Position, Off, Speed, Temperature, Time+Date,
Triplog, Voltage)

Depth Offset

(Advanced)

Depth Offset will adjust the digital depth readout to indicate depth from the waterline
or boat's keel. Enter a positive vertical measurement from the transducer to the
waterline to read the depth from the waterline. Enter a negative vertical measurement
from the transducer to keel to read the depth from the keel. This menu choice is
available only when in Advanced User Mode (see Setup Menu Tab: User Mode.)

To change the Depth Offset setting:

1. Make sure you are in Advanced User Mode, then highlight Depth Offset on the

Setup menu.

2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Depth Offset setting.

(-10.0 to +10.0 feet or -3 to 3 meters [International Models only], Default = 0)

Temp Offset

(Advanced)

Temp Offset will adjust the temperature readout by the amount entered. This menu
choice is available only when in Advanced User Mode (see Setup Menu Tab: User Mode.)

To change the Temp Offset setting:

1. Make sure you are in Advanced User Mode, then highlight Temp Offset on the

Setup menu.

2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Temp Offset

setting. (-10.0 to +10.0 degrees, Default = 0)