Hotpoint TCL770 - Manual (Page 5)

5
Impor
tant
Inf
ormation
Installation
Description
Star
t and
Pr
ogrammes
Laundr
y
W
arnings and
Sug
g
estions
Maintenance
and Care
Ser
vice
T
roub
leshooting
GB
Dryer Description
The Progress or Delay lights show you the status of
the programme, or the delay time when they flash.
During a delayed start the lights flash to show the
delay selected. When (not flashing) they show each
stage of the programme by the corresponding light
turning on (
see Start and Programmes ).
The Empty Water indicator light signals that the water
container should be emptied. The light will take a few
seconds to go out after replacing the empty water
container, the dryer must be running for this to happen
(
see The Controls ).
Note: If the water bottle fills the indicator light flashes, the
heat is turned off and your clothes will not dry.
The Clean Filter light gives you a reminder before
every programme that it is essential to clean the filter
every time the dryer is used (
see Maintenance and Care ).
The Clean Condenser light gives you a reminder that
it is essential to clean the condenser at regular intervals
(
see Maintenance and Care ).
The ON/OFF button : If the dryer is running and
this button is pressed, the dryer stops. Press again,
the dryer restarts.
The Drying Guide allows you to consult a user friendly
table of fabric types and load capacities.
The PROGRAMMES knob sets the programme: rotate
it until the indicator is pointing to the programme you want
to select (
see Start and Programmes ).
The OPTION buttons/lights select available options for
your selected programme. The lights indicate that the
option has been selected (
see Start and Programmes ).
The START/PAUSE button/light starts a selected
programme. When you press this button there will be
one beep and the progress lights will flash to confirm
the action. When a programme is running, holding this
button in pauses the programme and stops the dryer.
The light is green when programme is running, flashing
amber if the programme has been paused or flashing
green if on standby waiting to start a programme (
see
Start and Programmes ).
Control panel
Empty Water
Light Drying Guide
PROGRAMMES
Knob
START/PAUSE
Button & Light
Indicator
Progress or Delay
Lights
OPTION
Buttons & Lights
Clean Filter
Light
Clean Condenser
Light
ON/OFF
Button
To open the door The features
Water container
Air intake
grille
Rating plate
Filter
Model &
Serial
numbers
Condenser cover handle
(Pull to open)
Condenser cover
Press and release the front
panel in position shown
Condenser unit
(Cover open)