Hitachi P60X901 - Manual (Page 4)

4
Accessories
Check to make sure you have the following accessories before disposing of the packing material.
Power Cord Remote Control
Two “AA” size,
1.5V batteries
2 IR Blaster Cables
Power Swivel Table Top Stand
(P50X901 model only)
For U.S. models: For optional accessories, please access our web site at: www.hitachi.us/tv
CANADA only : For optional accessories, please access our web site at: www.hitachi.ca/tv
Power Swivel Cable
Two “AAA” size,
1.5V batteries
MUTE FAV CH
SELECT
VOL +
CH -
CH +
GUIDE
VOL -
MENU INPUTS
POWER
EXIT
Simple Remote
.
´ ³
»
º
¶
· ²
¾
¿
F
ir
s
t
ti
m
e
u
s
e
Wire Clamp
(P50X901 model only)
CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not
provide adequate ventilation for the electronics or proper support for the front glass
panel. This plasma television product is designed for a maximum tilting angle of 45
degrees from vertical.
2. This stand for use only with Hitachi P50 X901. Use with other apparatus is
capable of resulting in instability causing possible injury.
3. The wall mount unit for the 50" model is WM07S and for the 60" model is WM07L.
Please see page 7 for important information related to the wall mount. The Wall Mount
³ Remote Control Unit CLU-4372A ´ Power Cord (P art No. EV01841).
(Part No. HL02402). ² Two IR Blaster cables (P art No. EY01641).
· Simple Remote Control Unit CLU-123S ¶ Power Swivel Table Top Stand (Part No. QJ03754 P50X901 only)
(Part No. HL01864)
» Two “AA” size, 1.5V batteries
¿ Two “AAA” size, 1.5V batteries
º Power Swivel Cable (Part No. EW08433 P50X901 only).
¾ Wire clamp
1. Open the battery cover of the remote control by pushing down and sliding the back cover off.
2. Insert two new “AA” and "AAA" size batteries for the remote control and Simple Remote Control. When replacing
old batteries, push them towards the springs and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery
compartment.
4. Insert the bottom of the battery, the (-) side, into the battery
compartment first, push towards the springs and insert the
top of the battery, the (+) side, into place. Do not force the
battery into the battery compartment.
5. Replace the cover.
Lift up on tab to remove back cover.
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
CAUTION: Do not insert batteries with ‘+’ and ‘-’ polarities reversed as this may cause the batteries
to swell or rupture resulting in leakage.
Lift up on tab to
remove back cover.
BOTTOM VIEW
(Remote Control)
BOTTOM VIEW
(Simple Remote Control)
Lift up on tab to
remove back cover.
unit is an optional accessory (Not Included).
Optional Fixed Tabel Top Stand (Part No. STF0760 P60X901 only)
Fixed Table Top Stand
CH 3
(Part No. STF0760 P60X901 only)
Optional Fixed Tabel Top Stand
CH 3