Holman qt14 User Manual

Page 19

IF FURTHER ASSISTANCE IS REQUIRED:
CONTACT STAR/HOLMAN FACTORY SERVICE TEAM AT 1-800-807-9054

Note: During factory assembly, a 1/8” side-to-side
play is adjusted into the driveshaft to allow for
chassis expansion.

1. Unit must be cool
2. Do not adjust the sprocket on the driveshaft.
3. Insert a 1/16” spacer (drill bit etc) between the

driveshaft sprocket and the washer that is
outside the bearing.

4. Measure the distance “A” while holding the

sprocket against the spacer.

5. Adjust the sprocket on the drive motor so that

dimension “B” is equal to “A”

”.