Harbor Freight Tools 96514 - Manual (Page 8)

Page 8 For technical questions, please call 1-800-444-3353. ITEM 96513
2-Wheel Dirt Bike Loading
1. Do not attempt to load any dirt bike
or other 2-wheel motor bike alone.
Have a qualified adult assist.
2. Line up the 2-wheel dirt bike
with one of the Ramps.
3. With one person pushing the dirt bike
slowly up the Ramp, a helper
should be in the bed of the hauling
vehicle both to guide and to apply
the brake if it is necessary to stop
the dirt bike while it is on the Ramp.
Have one person with a hand on the
dirt bike hand brake for safety.
4. Once the person inside the truck bed
has hold of the handle bars, apply
the brake and steady the dirt bike
while the other person moves behind
the dirt bike (but off to one side) and
pushes it all the way into the truck bed.
NOTE: While most dirt bikes are light
enough to safely load with two people, a third
person can make the job easier and safer.
5. Once the dirt bike is safely loaded,
secure it with four tie down straps
(not included), one on each side
of the front, and one on each side
at the rear of the dirt bike.
2-Wheel Dirt Bike Unloading
1. Position the Ramp against the
truck tailgate behind the rear tire
of the dirt bike and attach the
Safety Chain to the truck bed.
2. Remove the tie-down
straps (not included).
3. Slowly and carefully while using
an assistant, push the dirt bike
backwards until the back tire is at the
top of the Ramp. With one person
on the ground behind and to the
side of the Ramp, slowly push the
dirt bike onto the Ramp. Someone
must always hold the hand brake.
4. Slowly work the dirt bike down the
Ramp and onto the ground.