Hotpoint WMA22 - Manual (Page 8)

When all selections
have been made press
the ‘START/Hold To
Reset’ button.
The ‘Prog End light
will go out and the
‘Active’ light will
illuminate to indicate
the start of a programme. After a short time
the ‘Door Locked’ indicator light will
illuminate.
To cancel a programme once the machine
has started, press and hold the ‘START/Hold
To Reset’ button for two seconds, until the
‘Prog End’ light flashes.
You can then make a new selection. Press
the ‘START/Hold To Reset’ button again to
carry on.
A Typical Wash Programme
Turn the programme
selector dial from the
‘OFF’ position to the
programme required
(see STEP 4).
The ‘Prog End’ light
will illuminate to
indicate that the
machine has power.
Sort laundry into
groups by washcare
labels.
Load the machine,
making sure that the
laundry is not
trapped in the door.
Close the door by
pushing it until it
clicks.
2
Select any optional
wash feature(s) that
you may require by
pressing the
appropriate button(s)
(see STEP 6) indicator
lights will show what
you have chosen.
3
During the wash, the
‘Active’ and ‘Door
Locked’ indicator light
will remain lit.
When the pro-
gramme has
finished the
‘Prog End’ and
‘Door Locked’
indicator lights
will remain lit.
After a short time the ‘Door Locked’
indicator light will go out. You can
then open the door.
To switch the machine off, return the
programme selector dial to the ‘OFF’
position.
The ‘Prog End’ light will go out.
We also recommend that you switch
off the electricity and water supply.
Add detergent (and
fabric conditioner if
required) to the
dispenser drawer (see
STEP 3).
Refer to the detergent
manufacturer’s
dosage instructions.
1
6 7
4
WARNINGS:
DO NOT allow
children to play
with the appliance
or tamper with the
controls.
DO NOT overload
the appliance!
It may damage the
laundry and reduce
the quality of the
wash.
DO NOT try to
open the door
when the ‘Door
Locked’ indicator
light is on.
During the wash
cycle, remember
that the door glass
may become hot to
the touch.
DO NOT open the
dispenser drawer
during any
programme.
5
STEP 7
If you stop a
programme part
way through a
wash or there is a
power cut, take
care when opening
the door, the
machine may
contain hot water.