Assembly step 2, Assembly step 3, Assembly step 4 – Horizon Fitness ELITE 4.2E User Manual
Page 5: 2e only, Warning
BEFORE
YOU
BEGIN
8
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
ELLIPTICAL
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
9
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ELLIPTICAL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY STEP 2
A) Open
HARDWARE BAG FOR STEP 2.
B) Slide left and right
FOOT LEVELERS
onto
MAIN FRAME.
C) Attach
FOOT LEVELERS using
WASHER (E) and BOLT (F).
��������
�����
������
���������������
�����
������
HARDWARE BAG FOR STEP 2 CONTENTS :
���������������
��������
������������
����������
���������
�������������
�����������������
������������
����������
���������������
���������
����������
ASSEMBLY STEP 3
�����������������
�����
������
�����������������������
����������
������
�����
�������
������
���������
�����
������
HARDWARE BAG FOR STEP 3 CONTENTS :
A) Open
HARDWARE BAG FOR STEP 3.
B) Slide
TEFLON SHEET WASHER (G),
PEDAL ARM and TEFLON WASHER
(H) over PEDAL ARM BRACKET
C) Secure
PEDAL ARM to PIVOT TUBE,
using
NYLON NUT (I).
D) Attach
PEDAL ARM COVER using
SCREW (J).
E) Repeat on other side.
������������
�������������
������������
����������
������������
�����
���������
���������������
���
�����
ASSEMBLY STEP 4
���������
�����
������
��������
�����
������
HARDWARE BAG FOR STEP 4 CONTENTS :
NOTE: There is NO hardware for steps
A-D. All hardware is pre-installed.
A) Remove
PRE-ATTACHED BOLT &
WASHERS from CONSOLE MAST.
B) Slide
LOWER HANDLEBAR onto
CONSOLE MAST and attach by re-
inserting
PRE-ATTACHED BOLT &
WASHER.
C) Slide
UPPER HANDLEBAR onto
LOWER HANDLEBAR and align
NOTCH with TAB making sure
handlebars are joined together
completely. Secure
UPPER
HANDLEBAR to LOWER HANDLEBAR
using
PRE-ATTACHED SET SCREWS.
D) Repeat on other side.
WARNING
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
E) Open
HARDWARE BAG FOR STEP 4.
F) Attach
FRONT & BACK HANDLEBAR
COVERS using 2 SCREWS (K) and 2
BOLTS (L) for each side.
4.2E ONLY
���������
���������
������
���������
���������
4.2E ONLY
4.2E only
Elite 3.2E 4.2E Elliptical Rev 1.0.indd 8-9
7/13/05 2:47:56 PM