Hoover Wet/Dry Vac - Manual (Page 9)

9
Problem: Loss of air suction
• Possible Cause
•
Possible Solution
• Obstruction in hose, wand or tool.
•
Clear obstruction.
• Clogged cartridge or foam filter.
•
Clean filter as described in
“Maintenance” section.
• Hole/split in hose.
•
Inspect and replace hose.
• Automatic shut-off engaged.
•
See “Automatic wet shut-off”
section
Service
To obtain approved HOOVER
service and genuine HOOVER parts,
locate the nearest
Hoover Factory
Service Center or Authorized
Hoover Warranty Service Dealer
(Depot)
by:
• checking the Yellow Pages
under “Vacuum Cleaners -
Household” OR -
• checking the list of Factory
Service Centers provided with
this cleaner OR -
• calling 1-800-944-9200 for an
automated referral of authorized
service outlet locations
(U. S. only) OR -
• checking the Service section of
The Hoover Company online at
www.hoovercompany.com
Do not send your cleaner to The
Hoover Company in North Canton
for service, this will only result
in delay.
If further assistance is needed,
contact The Hoover Company
Consumer Response Center,
North Canton, Ohio 44720 Phone:
330-499-9499.
In Canada, contact Hoover Canada,
Burlington, Ontario L7R 4A8,
Phone: 1-800-263-6376.
Always identify your cleaner by the
complete model number when
requesting information or ordering
parts. (The model number appears
on the portable blower.)
If you have a
problem
If a minor problem occurs, it usually
can be solved quite easily when the
cause is found by using the
checklist below.
Problem: Cleaner won’t run
• Possible Cause
•
Possible Solution
• Not firmly plugged in.
•
Plug cleaner in firmly
• No voltage in wall plug.
•
Check fuse or breaker.
• Blown fuse/tripped breaker.
•
Replace fuse/reset breaker.