HONDA Outboard Motor BF115A - Manual (Page 95)

10 A, 30 A
93
BATTERY WILL NOT
CHARGE AND ELECTRIC
STARTER WILL NOT
OPERATE Fuse Replacement
TAKING CARE OF UNEXPECTED PROBLEMS
FUSE COVER
SPARE FUSE (10A, 30A)
FUSE (10A, 30A)
Main Fuse
Never use a f use with a rating
greater than specif ied. Serious
damage to the electrical system
could result.
Reinstall the fuse covers and the
engine cover.
The battery-charging (ACG) circuit
and the electric starter relay circuit
are protected by the 10 and 30-
ampere main fuses and 90-ampere
ACG fuse. If a fuse burns out, the
engine will not charge the battery,
and the electric starter will not
operate.
The ignition switch is protected by
the 10-ampere main fuse. If the fuse
burns out, the engine will not start or
run, and the power trim/tilt switch
will not operate.
Remove the engine cover.
Remove the fuse covers.
Remove and inspect the fuses. If a
fuse is burnt out, install a
replacement fuse of the specified
rating. The outboard motor is
supplied with spare fuses in the
fuse holders.
MAIN FUSES:
Reconnect the battery.
Before further operation, try to
determine and correct the electrical
problem that caused the fuse to
burn out. An uncorrected electrical
problem may cause the fuse to
burn out again.
Stop the engine and disconnect the
battery cable. 1.
2.
3.
4.
5.
6.
05/02/22 12:45:26 31ZW5601_094