Hotpoint RZA50 - Manual (Page 15)

Door Reversal
15
Note : You may require assistance to do this:
25. Place the top hinge onto the door, slide the door onto the
bottom hinge pin and support the door whilst screwing the top
hinge bracket into position.
Ensure that the top hinge bracket is positioned correctly.
26. Adjust the front feet (see ‘Levelling’ SAFETY & INSTALLATION section).
27. Fit the bottom hinge covers (see ‘Hinge Covers’ in the SAFETY &
INSTALLATION section).
21. Turn the handle vertically, top to bottom and place against the right hand
side, position sealbreaker blade into the seal pocket.
22. Secure the handle in place with the original fixing screws, ensuring free
movement of mechanism.
Door Handle Reversal:
Note: This MUST be completed with the door OFF the product.
18. Remove the hole plugs from the right hand side of the door.
20. Unscrew the handle fixing screws and carefully
remove the handle from the door.
WARNING: Take care not to dislodge the internal
mechanism when removing the handle from the
door.
19. Unclip the handle snap-clip cover using a screwdriver
and rotate to reveal the handle fixing screw.
23. Rotate and snap-clip handle covers back in original
position.
24. Use the hole plugs removed from the right hand side
to fill the holes on the left.
door stop
seal stop
14. Carefully lie the door down onto its interior lining.
We recommend that you lie the door onto a suitable
protective material (ie. the original packaging).
15. Remove the seal stop on the top left of the door:
Remove the fixing screw, then using a thin blunt
instrument, lever the seal stop off the door.
Repeat to remove the seal stop on the bottom left.
16. (if applicable) Use a screwdriver to remove the door
stop from the bottom right of the door and refit on
the bottom left, if fitted to your model.
17. Refit the seal stops, one top right the other bottom right.
Push into position and secure with fixing screw.
CLEANING &
MAINTENANCE