Hotpoint HDA2200 - Manual (Page 10)

Safety Information
Operating Instructions
Troubleshooting T
ips
Customer Service
About the dishwasher control panel.
Rinse Only
For rinsing partial loads that will be washed later. Do not
use detergent.
Make sure ENERGY SAVER / HEATED DRY OFF is selected.
Be sure the door is unlatched.
Slowly turn the Dial to RINSE ONLY.
Latch the door to start the cycle. 4
3
2
1
START
OFF
HOT
PREWASH
OPTION WATER SAVER
RINSE ONLY (HEATED DRY OFF) (HEATED DRY ON)
PLATE WARMER
10
Delayed Start
The HOURS DELAY will allow you to delay the start
time of any cycle not on the Dial automatically for up
to 6 hours.
Be sure the door is unlatched.
Select the wash cycle and option you want.
Slowly turn the Dial to desired time. The DELAYED
START light will come on.
Latch the door to start the cycle. 4
3
2
1
HOURS
DELAY
OFF
RINSE ONLY
PLATE WARMER
(HEATED DRY OFF)
(HEATED DRY ON)
START
WATER
SAVER
HOT PREWASH OPTION
5
4
2
3
1
About the dial cycles.
Start
Slowly turn the Dial to the START or ON position, or the selected cycle.
Don’t turn it past the START, ON or cycle position, or you could
accidentally miss a rinse. For models HDA2120 and HDA2130, when
using the POTS & PANS cycle, slowly turn the Dial to the NORMAL/POTS
& PANS position and press the POTS & PANS ON button. When using
the NORMAL cycle, slowly turn the Dial to the NORMAL/POTS & PANS
position and press the POTS & PANS OFF button. See About the Dial
Cycles section for other cycles on these models.
There is a time delay between start-up and water fill so you will not
hear any wash action right away.
■ Latch the door to begin the cycle.