Operation – HONDA BFP8D User Manual
Page 52
50
OPERATION
RECOIL STARTER
ASSEMBLY
FLYWHEEL (STARTER PULLEY)
KNOT
RECOIL STARTER
ASSEMBLY
NEUTRAL START CABLE
STARTER ROPE
FLANGE BOLT
TAKING CARE OF
UNEXPECTED PROBLEMS,
Set the knotted end of the
emergency starter rope in the notch
in the flywheel. Wind the rope
clockwise around the flywheel, as
shown.
Set the controls the same as for
normal starting (see pages
). Use the choke and fast idle
controls if needed.
Turn the ignition switch key to the
ON position.
Unscrew the three flange bolts and
remove the recoil starter assembly.
Move the shift lever to the F
(forward) position. Loosen the
neutral start cable lock nut and
disconnect the neutral start cable.
Pull the emergency starter rope
slowly until resistance is felt, then
pull briskly.
Keep away from moving parts
while pulling the rope.
If necessary, rewind the rope and
pull again. If the engine does not
start after several attempts, refer to
2.
3.
5.
4.
6.
04/03/15 10:30:28 31ZY0600_051