Hoover 1130 - Manual (Page 3)

TO ATTACH HANDLE TO CLEANER
Remove tape and screw from h an d 1 e s o c k e t. Set screw aside for
later use.
Connect electric plug from bottom of handle to electric plug projecting
from handle socket. Make sure plug assembly is positioned as shown
in illustration.
3. Push handle into place in handle socket. The excess wire and electric
plugs are guided into handle tube.
4. Line up holes in handle and handle socket. Insert screw and tighten
with screwdriver.
Be sure that screw is tightened securely.
HANDLE
ADJUSTMENTS
The handle on your clean-
er has three positions
storage,
operating, and
low (for reaching under
low furniture). The handle
can be lowered by step-
ping on pedal at the left
rear
of cleaner. The
handle should always be
in storage position when
cleaning tools are used.