Hughes & Kettner CF 200 - Manual (Page 4)

( 11 ) BRIDGE MODE
The MODE switch ( 12 ) determines whether the CF 200 operates in the 2 x 1 OOW
stereo mode, or in the 200W mono mode. To avoid accidental switching between
modes, a plastic coverplate is screwed in position. Ensure that the upper and
lower screws are never removed simultaneously. When the MODE switch ( 12 ) is
in the MONO BRIDGE position, the CF 200 operates as a mono 200W amp. Use
the two binding posts to connect speaker cabinets. Ideally, use cables with
terminals or banana plugs. Minimum impedance: 8 ohms.
Black binding post: negative. Red binding post: plus
The INPUT RIGHT and the VOLUME RIGHT control are activated in the
BRIDGE MODE.
( 13 ) INPUTS
The input jacks are suitable for preamps or mixers. Both channels automatically
amplify the signal if only the INPUT RIGHT jack is accessed. In the BRIDGE
MODE, only the INPUT RIGHT is activated.
SIGNAL ROUTING DIAGRAM
HUGHES KETTNER CF 200
line Out left line Out Right
Input left Input Right
Stereo Speaker Outs
left Right
Input input
Cabinets e.g. HUGHES KETTNER