Tsurumi TPG-2900H-DX - Manual (Page 86)

INSTALLATION OF BATTERY ENCLOSURE
1. Position assembled enclosure on crossover support on bottom of generator frame. Install two bolts
(11) through support tubes (1) and generator frame. Install and tighten nuts (12).
2. Align holes in support tubes (1) with holes in upper frame. Install two bolts (13) and nuts (14).
3. Check to make sure all bolts and nuts are tight.
Page A-3 Appendix A
Tsurumi’s Operation, Service, and Repair Manual
INSTALLATION OF BATTERY
1. Set battery on base plate (2). Place hold-down plate (4) on front edge of battery.
2. Install hooked end of tie-down rods (5) in holes in base plate (2). Put threaded ends of tie-down
rods (5) up through holes in hold-down plate (4).
3. Install raised edge clips (6) toward terminals. Install wing nuts (7) on tie down rods. Tighten wing
nuts (7).
4. Connect battery cables to terminals.
5. Start the generator to verify that the battery is properly connected.
CLIP, SPRING
WASHER, AND
WING NUT
HOLD-DOWN
PLATE (4)
BASE
PLATE (2)
TIE-
DOWN
ROD