Harbor Freight Tools PACIFIC HYDROSTAR 95267 - Manual (Page 5)

Page 5 SKU 95267
Hose Fitting Sizes
Installation (continued)
Hose Connection: The Universal Fitting (42), in Figure B, connects to various hose sizes.
The hoses should be connected using a step nipple (not included). The 1” and 1-1/4” hoses
should also be secured with hose clamps (not included). The largest connection (1-1/2”) will
yield the greatest flow. The top of the Universal Fitting may be removed to fit on various size
hoses (see Figure B). Use a knife to gently trim any unneeded material.
Figure B
Figure C
Note: Use a pipe joint sealant to ensure air tight operation.
Figure C (Removing Base to clean Impeller)
G
Vent Valve
1-1/2” 1-1/4” 1”
Float Switch (1)
Connect the Universal Adapter (42) here.
Note: (Optional) To reduce vibration and noise, a short section of rubber hose (1-1/4” x 1-
3/8” inside dia.) may be attached to the discharge line, using clamps (hose and clamps not
included).
Figure A