Harman-Kardon 210 - Manual (Page 32)

32 ADVANCED FEATURES
Advanced Features
activated, even if they were switched off for the
previous listening session.
To change the length of time that the semi-OSD
displays remain on the screen, go to the
ADVANCED SELECT menu as outlined
earlier, and press the
⁄ / ¤ buttons mq as
needed, until the on-screen › cursor is next to
the SEMI-OSD TIME OUT line. Next,
press the
‹ / › buttons n until the
desired time in seconds is displayed. Note that,
unlike most of the other options in this menu,
this is a permanent setting change, and the
time-out entry will remain in effect until it is
changed, even when the unit is turned off.
If you wish to make other adjustments, press
the
⁄ / ¤ buttons mq until the on-screen
› cursor is next to the desired setting or the
RETURN TO MENU line and press the Set
button
o. If you have no other adjustments
to make, press the OSD button v to exit the
menu system.
Full-OSD Time Out Adjustment
The FULL-OSD menu system is used to
simplify the setup and adjustment of the
AVR 210 using a series of on-screen menus. The
factory default setting for these menus leaves
them on the screen for 20 seconds after a
period of inactivity before they disappear from
the screen or “Time Out.” Time Out is a safety
measure to prevent image retention of the
menu text in your monitor or projector, which
might happen if menus were left on indefinitely.
However, some viewers may prefer a slightly
longer or shorter period before the Time Out
display.
To change the Full-OSD Time Out, you will need
to make an adjustment in the ADVANCED
SELECT menu (Figure 9). To start the
adjustment, press the OSD button
v to bring
the MASTER MENU to the screen. Press
the
¤
button q six times, until the on-screen
¤
cursor is next to the ADVANCED line.
Press the Set button o to enter the
ADVANCED SELECT menu (Figure 9).
At the ADVANCED SELECT menu
(Figure 9), make certain that the on-screen
›
cursor is next to the FULL-OSD TIME
OUT line by pressing the
⁄ / ¤ buttons
mq as needed. Next, press the ‹ / › but-
tons n until the desired time is displayed
in seconds. Note that unlike most of the other
options in this menu, this is a permanent set-
ting change, and the Time Out entry will remain
in effect until it is changed, even if the unit is
turned off.
If you wish to make other adjustments, press
the
⁄ / ¤ buttons mq until the on-screen
› cursor is next to the desired setting or the
RETURN TO MENU line and press the Set
button
o. If you have no other adjustments
to make, press the OSD button v to exit the
menu system.
31
31