Humminbird 515 - Manual (Page 60)

55
To Select Readouts:
1. Make sure you are in Advanced User Mode, then highlight Select
Readouts on the Setup main menu.
2. Use the RIGHT 4-WAY Cursor Control key to initiate this procedure.
3. The Select Readouts submenu will appear, showing a list of all
Readouts. Use the UP or DOWN Cursor keys to select a particular
Readout position, then use the RIGHT or LEFT Cursor keys to change
what will be displayed at that position. (Off, Speed, Temperature,
Triplog, Voltage)
Depth Offset
(Advanced)
Depth Offset will adjust the digital depth readout to indicate depth from the
waterline or boat's keel. Enter a positive vertical measurement from the
transducer to the waterline to read the depth from the waterline. Enter a
negative vertical measurement from the transducer to keel to read the depth
from the keel. This menu choice is available only when in Advanced User Mode
(see Setup Menu Tab: User Mode).
To change the Depth Offset setting:
1. Make sure you are in Advanced User Mode, then highlight Depth
Offset on the Setup menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Depth
Offset setting. (-10.0 to +10.0 feet or -3 to 3 meters [International
Models only], Default = 0)