HONDA MM60 - Manual (Page 14)

SET-UP AND ASSEMBLY
Lift Unk
Lower Link Shaft
Y- bracket
Attaching Lift Link to Lift Plate Assembly
(For Tractors Without Rear Three Point Hitch)
Slide middle hole in lift link onto greased left
hand lower link shaft which comes installed on
the tractor. Install lift link so that it is vertical and
the end with two holes is down. Lift link should
face as illustrated. Be sure to apply
grease to shaft. Secure with linchpin.
2. Use a block of wood to raise left arm of lift plate
assembly about 150 mm (6 in) to make attach-
ing the Y-bracket and the bottom hole of the lift
link easier. Line up hole in Y-bracket with lower
hole in
lift link moving arm and lift link until they
align. Insert greased 22 mm x 76 mm clevis pin
and secure with cotter pin, passing pin from
top to bottom. Head on clevis pin faces in.
Attaching Lift Link to Lift Plate Assembly
(For Tractors With Rear Three Point Hitch)
1. Remove left hand three point hitch lower link
from lower link shaft.
2. Mount lift link and-lower link back on lower link
shaft by lining up middle hole in lift link and hole
in lower link. Pass greased lower link shaft
through both as illustrated. Secure with linchpin,
passing pin from top to bottom.
3. Support lift plate assembly arms on block of
wood as described above. Move lift link and Y-
bracket on lower lift plate assembly until hole in
Y-bracket and bottom hole in lift link line up.
Insert greased 22 mm x 57 mm clevis pin with
head facing in and secure with cotter pin,
passing pin from top to bottom.
Lower Link
12