Heritage Kayaks Heritage Series - Manual (Page 28)

Heritage Series ADSL Bridge/ Router
23 Installing and Configuring your ADSL Router
4. Then you will see the following prompt, DSL > (“DSL” for
example in here, instead of your ADSL Router’s Model).
5. Now you are ready to configure the Router by using command.
Please contact your ISP/NSP to obtain the detail command sets of
your Router. If the Router does not return any message, refer to
Appendix B
for troubleshooting information.
2.4.2 Using terminal program via serial console port
A terminal can be connected directly to the Serial console port. This
requires the use of a terminal emulation software package such as
Microsoft HyperTerminal. By default setting, the Router is configured to
communicate at a baud rate of 9600. Any standard terminal that support
baud rate of 9600 can be connected to the Router’s console port. Please
configure your serial port as:
BPS : 9600
Data bits : 8
Parity : None
Stop Bits : 1
Flow Control : None
Following steps provide the instructions to log on to the Router via
Microsoft HyperTerminal.
1. Select Start->Programs->Accessories->HyperTerminal