Hitachi UltraVision 32UDX10S - Manual (Page 5)

5
BOTTOM VIEW
Lift up on tab to
remove back cover.
REMOTE CONTROL BATTERY INSTALLATION
AND REPLACEMENT
1. Open the battery cover of the remote control by pushing the
notched part of the cover with your fingers, and pulling the
cover off.
2. Insert two new AA size batteries in the remote. When
replacing old batteries, push them towards the springs and
lift them out.
3. Match the batteries to the (+) and (-) marks in the battery
compartment.
4. Replace the cover.
NOTES:
1. If your color television set is to remain unused for a long period of time, for instance when you go on vacation, unplug the
color television from the wall outlet.
2. Do not subject the remote control to shocks such as dropping it on the floor, etc. Precision parts may be damaged.
3. Do not allow the remote control to become wet and avoid placing it in areas of high humidity. Do not leave it on or near a
heater. Excess heat or moisture may cause the unit to cease operation.
4. If the batteries become exhausted, remote control operation may become erratic or stop altogether. Replace the old batteries
with new AA types.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalant type.