Harbor Freight Tools CHICAGO ELECTRIC 38391 - Manual (Page 4)

Page 4 For technical questions, please call 1-800-444-3353. SKU 38391
controls and
components
charging
note: After purchase and before initial
use, fully charge the Jump-Start
battery until the DC charging LED
turns off.
warning! The ON/Off switch (See
Figure 1) regulates power to the
clamps only. Keep it in the “Off”
position except when jumpstarting.
120 v~ charging
1. Plug the Power Cord (5) into a wall
outlet and plug the female end of
the Power Cord into the 120V male
Charging Plug of the 120V~ Charging
Port (see Figure 2, above).
2. Before first use, fully charge the
Jump-start battery until the dc
charging led turns off.
3. after each jump start, fully
recharge the battery until the dc
charging led turns off. it may
take up to 48 hours to fully charge
the Jump-start battery. Check the
progress by pressing the Voltage Test
Switch. The level of battery power
will then display on the Test Meter.
4. Fully recharge Jump start battery
every 30 days to ensure long
battery life and reliability.
note: The charger unit comes equipped
with an automatic shut off LED to
prevent overcharging. Leave the unit
plugged in to make sure it is charged
for emergencies.
Red
Clamp Work
Light
Black
Clamp Test
Meter
Jump Start ON/OFF
Light
Switch
Voltage
Test
Switch
DC Charging
Light
Charging
Receptacle
120 V
Charging
Plug
(Male)
Cigarette
Lighter
Plug-In
Figure 1
Figure 2
Power
Cord (5)