Harbor Freight Tools DRILL MASTER 97626 - Manual (Page 3)

Page 3 For technical questions, please call 1-800-444-3353. SKU 97626
Electrical safety
1. power tool plugs must match
the outlet. never modify the plug
in any way. Do not use any adapter
plugs with grounded power tools.
Unmodified plugs and matching outlets
will reduce risk of electric shock.
2. Do not expose power tools
to rain or wet conditions.
Water entering a power tool will
increase the risk of electric shock.
3. Do not abuse the cord. never use
the cord for carrying, pulling or
unplugging the power tool. Keep cord
away from heat, oil, sharp edges or
moving parts. Damaged or entangled
cords increase the risk of electric shock.
4. if operating a power tool in a damp
location is unavoidable, use a
Ground Fault Circuit interrupter
(GFCi) protected supply. Use of a GFCI
reduces the risk of electric shock.
personal safety
1. Stay alert, watch what you are
doing and use common sense when
operating a power tool. Do not use
a power tool while you are tired or
under the influence of drugs, alcohol
or medication. A moment of inattention
while operating power tools may
result in serious personal injury.
2. use personal protective equipment.
always wear eye protection.
Safety equipment such as dust mask,
non-skid safety shoes, hard hat, or
hearing protection used for appropriate
conditions will reduce personal injuries.
3. prevent unintentional starting.
Ensure the switch is in the off-position
before connecting to power source,
picking up or carrying the tool.
Carrying power tools with your finger on
the switch or energizing power tools that
have the switch on invites accidents.
4. Remove any adjusting key or wrench
before turning the power tool on.
A wrench or a key left attached to
a rotating part of the power tool
may result in personal injury.
5. Do not overreach. Keep proper
footing and balance at all times.
This enables better control of the
power tool in unexpected situations.
6. Dress properly. Do not wear loose
clothing or jewelry. Keep your hair,
clothing and gloves away from moving
parts. Loose clothes, jewelry or long
hair can be caught in moving parts.
7. if devices are provided for the
connection of dust extraction and
collection facilities, ensure these
are connected and properly used.
Use of these devices can reduce
dust-related hazards.
8. Only use safety equipment
that has been approved by an
appropriate standards agency.
Unapproved safety equipment may
not provide adequate protection.
Eye protection must be ANSI-approved
and breathing protection must be
NIOSH-approved for the specific
hazards in the work area.
Sa
FE
tY
Op
ER
ati
O
n
m
aint
Enan
CE
SE
tup