haier HWM120-01 - Manual (Page 16)

Selection method of the procedure programs
Times of pushing
the PROCESS
button
Selected procedure
program
Applicable procedure
Contents (the lighted indicators
indicate the programs about to run)
Wash, rinse, spin
(standard program)
Wash (the washing liquid
remains in the tub)
Wash (the rinsing liquid
remains in the tub)
Repeat using the washing liquid
Repeat using the rinsing liquid
Rinse, spin
Spin
(spin after drain)
When the laundries need rinsing and
spinning after hand washing
When the laundries only need spinning
after hand washing(first spin then drain)
If the laundries are very dirty, or the sleeve
and collar are dirty, first soak then wash
soak wash, rinse, spin
If you push the process button for 6 times, it will resume the initial mode, and it will circulate in that way.
The soak program can be used as fitting of the standard/jeans automatic programs.
It will do soaking with intermittent stirring of pulsator.
After the washing machine starts working, you can only make selection during wash , and cannot make selection
during other procedures.
When the common laundries need
washing , rinsing and spinning
Wash
Wash
Wash
Wash
Wash
Wash
Rinse Spin
Rinse Spin
Rinse Spin
Rinse Spin
Rinse Spin
Rinse Spin
Soak
Soak
Soak
Soak
Soak
Soak
Push the WATER LEVEL button to selection suitable water level
Time list of each program (minute)
Program water level Wash (min) Rinse (min/time) Spin (min) Total time (min)
Standard
Jeans
Gentle
Quick
Rinse twice , each about 4
Rinse with water inlet twice,
each about 4
Rinse twice , each about 4
Rinse once , each about 2
1~12
1~12
1~12
About 4
10~15
About 3
About 3
About 6
About 6
About 2
About 2
40~53
40~54
About 24
About 15
When the power is switched on, you need to set the suitable water level by yourself.
Refer to the water level, water quantity and selection of powder in Page 10
and water level in Page 11 for the selection.
Page 10 Page11
10~15
WATER
LEVEL