Locke C-125 - Manual (Page 13)

Installing Your Sulky Attachment
1. Remove Caster Assembly and Grease Fitting.
2. Install Lower Vertical Pivot Clamp #5 in place
of the Caster Assembly and lock in place with (2)
Setscrews #15. Install (1) Bearing Cup Assembly #10 in
the Pivot Clamp #5 using Bolt #12 and Nut #11.
3. Install Sulky by placing Sulky Gusset #2 in the
Bearing Cup Assembly #10 of Lower Vertical Pivot Clamp
#5, then install Upper Vertical Pivot Clamp #4 over Sulky
Gusset #2 and around traction unit frame tube with a
second #10, #11 and #12. Tighten all bolts and grease
the (6) grease fittings.
2
12
4
10
11
Figure 8
Figure 7
Figure 5
10
5
11 12
10
15
Figure 6