Hitachi 50VF820 - Manual (Page 27)

27
The Remote Contr
o
l
OPERATING THE PRECODED
FUNCTION FOR YOUR CABLE BOX.
This remote is designed to operate different types of
cable boxes. You must first program the remote to
match the remote system of your cable box (refer
below for pre-codes).
1. Turn ON your cable box.
2. Aim the remote control at the front of your cable
box.
3. To switch to Cable (CBL) pre-coded mode, press
and release the CABLE (CBL) button.
4. Hold down the CBL button on the remote and
enter the two digit preset code that matches your
cable box, as shown below. Release the CBL
button.
5. Aim the remote at the cable box and press the
POWER button. The remote will turn off your cable
box when the correct two digit preset code is
entered. When this occurs, the remote control is
programmed for your cable box. If the cable box
does not turn off, try a different two digit preset
code.
6. The remote will now control your Cable box.
NOTE: 1. If your cable box cannot be operated after
performing the above procedures, your
cable box code has not been precoded
into the remote.
2. In the unlikely event that your cable box
cannot be operated after performing the
above procedures, please consult your
cable box operating guide.
3. The remote control will remember the
codes you have programmed until the
batteries are removed from the remote
control. After replacing the batteries
repeat the entire programming procedure
as stated above.
³ CABLE (CBL) button
This button allows the remote to control your cable
box by setting it to CABLE mode.
· PRECODED CABLE BOX buttons
These buttons transmit the chosen precoded cable
codes.
» EXCLUSIVE TV buttons
These buttons are for operating the TV.
CABLE BRAND CODES
HAMLIN......................................................22, 23, 24, 25
JERROLD ......................... 00, 01, 02, 03, 04, 05, 06, 07
OAK..................................................................26, 27, 28
PANASONIC.................................................... 18, 19, 20
PIONEER ................................................................13, 14
SCIENTIFIC ATLANTA ......................................08, 09, 10
TOCOM ..................................................................15, 16
ZENITH...................................................................11, 12
MY CABLE BOX CODE IS: _______________________
NOTE: Refer to instruction manual of the Cable Box
for operation of the buttons exclusively for
the Cable Box.
The Remote Control for Cable Box Functions
·
»
»
·
·
³