Harbor Freight Tools 43430 - Manual (Page 4)

Page 4 SKU 43430
21. Read all information concerning coating products and cleaning solvents.
Chlorinated solvents (e.g., 1-1-1 Trichlorethylene and Methylene Chloride, also known
as methyl chloride) can chemically react with aluminum and may explode. Many paint
sprayers contain aluminum. If you have any doubt about potential chemical reactions,
contact the solvent or coating manufacturer.
22. Materials used when painting or cleaning may be harmful or fatal if inhaled or
swallowed. Use only in an area with adequate ventilation. Use a respirator or mask
when painting or using cleaning solvents (see number 9 of this list).
23. Never release the sprayer lid while the cup is pressurized. The paint could burst out
and contaminate your body.
24. Be aware of other people and animals. Do not use the sprayer near children or
animals. Keep all visitors away from the work area. Do not let children or visitors
handle tools.
25. Industrial applications must follow OSHA requirements.
26. Be aware of air hoses and their connections. Do not trip over hoses. Make sure all
connections are tight.
27. Maintenance. For your safety, maintenance should be performed regularily by a
qualified technician.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure that all the parts are included. (See the Parts List and
Assembly Drawing at the end of this manual.) If any parts are missing or broken, please call
Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Assembly
During the following procedure, refer to the Assembly Drawing on page 10.
1. Before operation, check all sprayer seals before connecting to the air supply.
2. Insert the Material Sleeve (8) into the Cup Connector (25).
3. Attach and fully secure the Plastic Cup (9) to the Cup Connector (25).
4. Attach and fully secure the Air Regulator (16) to the Gun Body (26) handle Air
Connector (7).
Warning: The brass components of this product contain lead, a chemical known to the
State of California to cause birth defects (or other reproductive harm). (California Health
& Safety code § 25249.5,
et seq. )
REV 01/07