Hayter Mowers Harrier 41 Electric - Manual (Page 10)

ASSEMBLING THE MOWER
1.10
Remove the mower from the packaging and check that the following
items have been supplied correctly. If any items are missing contact,
your local Hayter dealer.
1. Owner’s Handbook.
2. Grassbag.
3. Supply Cable - (309A Only)
To prevent accidents cut off the long ribbon attached to the grass-
bag and discard.
Unscrew the handlebar securing knobs sufficiently to allow the han-
dlebar to pivot. Hold the engine stop lever in towards the handlebar
and unfold the handlebar to the operating position, before releasing.
Tighten both handlebar knobs to secure in position.
Take care to ensure that the control cables do not become snagged at
the pivot point.
Raise the rear deflector, lower the grassbag through the handlebar and
hook in position. Lower the deflector to rest on the grassbag
Unpack the supply cable and identify the female socket end which is
to be attached to the mower. Fold back the hinged protector cap and
plug into the handlebar switch control unit. The hinged cap should
snap into position behind the control unit when fully engaged.
Route the supply cable loosely across to the cable cleat on the left side
of the handlebar. Make a loop in the supply cable and secure to the
cable cleat.
Handlebar
Delivery Checklist
Grassbag Attachment
Supply Cable