Hunter Fan hunter 42027-01 - Manual (Page 7)

6
Hunter Fan Company 42027-01 • 12/09/05
7
42027-01 • 12/09/05 Hunter Fan Company
3 • Assembling and Hanging the Fan (Low Profile Only)
You can assemble your fan for standard or angle mounting as shown
in steps 3-1 – 3-6 on the previous page. For low profi le mounting
(ceilings less than 8 feet high), see steps 3-7 – 3-11 on this page.
3-7. Locate the washer that comes preassembled in the canopy.
Remove the label and discard the washer and label. Locate the set
screw preassembled in the adapter. Remove and discard the set
screw. (Refer to images on previous page.)
3-8. Place the low profi le washer from the parts sack into the canopy.
3-9. Place the canopy trim ring and canopy with washer on top of the
fan assembly.
3-10. Align the screw holes in the washer with the holes in the adapter.
Assemble securely with three #8-32 x 1/2” screws.
3-11. Raise the fan and place the hook on the hanger bracket through
the round hole in the rim of the canopy.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Steps 3-8 – 3-10
#8-32 x 1/2” Screw
Low Profi le Washer
Canopy
Trim Ring
Adapter
Step 3-11
Step 3-10 (Detail)
Low Profi le Washer
(Not Actual Size)
Hanger
Bracket
Round
Hole
Hook
Do not remove the protective wrap
from the silhouette on the motor
housing. You will remove it after the
last step on page 13.