Hotpoint FZ92P - Manual (Page 3)

WARNING: This appliance must be earthed.
Fuses
Your appliance comes fitted with a plug and a 13A fuse. If you need to replace the fuse, only
those rated at 13A and ASTA approved to BS1362 should be used. If you lose the fuse cover,
a replacement may be obtained from your local Electricity company.
Correct replacement is identified by colour coding or the marking on base of plug.
WARNING: Do not use plug unless fuse cover is fitted.
Changing the Plug
Cut off and dispose of the supplied plug if it does not fit your socket.
WARNING: To avoid a shock hazard do not insert the discarded plug into a socket
anywhere else.
IMPORTANT: WIRES IN THE
MAINS LEAD ARE COLOURED
IN ACCORDANCE WITH THE
FOLLOWING CODE:
Green/Yellow - Earth
Blue - Neutral
Brown - Live
If you change the plug, the colour of
wires in the mains lead may not
correspond with the colour of the
markings identifying terminals in the
plug. You should therefore wire it as
shown.
Changing the Mains Lead
A special lead can be ordered from our Service Department UK: 08709 066 066 or
Republic of Ireland: 1850 302 200
If you have damaged the existing lead or require a longer one a charge will be made. It is
strongly advised that this work is carried out by a qualified electrician.
CE marking certifies that this appliance conforms to the following EEC directives:-
Low Voltage Equipment - 72/23/EEC & 93/68 EEC
Electromagnetic Compatibility - 89/336/EEC, 92/31/EEC & 93/68/EEC
3
Electrical Supply
Green and yellow (Earth)
wire to terminal
marked ‘E’,
symboL, or
coloured green
and yellow.
Blue (Neutral)
wire to terminal
marked ‘N’ or
coloured black.
13A ASTA approved
fuse to BS1362.
Brown (Live)
wire to terminal
marked ‘L’ or
coloured red.
Cord clamp