Homelite VERSALITE UT41002A - Manual (Page 15)

Page 15
1. Lubricate with Homelite silicone spray.
2. Install more line (Refer to “Replacing the
Cutting Line” earlier in this manual).
3. Pull lines while alternately pressing down
on and releasing spool retainer.
4. Remove line from spool and rewind (Refer
to “Replacing the Cutting Line” earlier in
this manual).
Clean threads and lubricate with grease. If no
improvement, replace spool retainer.
Cut tall grass from the top down.
Line will not advance when tap
retaining cap
Retaining cap is hard to turn
Grass wraps around the
attachment shaft and the
trimmer head assembly
1. Line is welded to itself.
2. Not enough line on spool.
3. Line is worn too short.
4. Line is tangled on spool.
Screw threads are dirty or dam-
aged.
Cutting tall grass at ground level.
PROBLEM POSSIBLE CAUSE SOLUTION
TROUBLESHOOTING