Harman-Kardon AVR65 - Manual (Page 10)

Rear Panel Connections
10
AVR65 120 volt Rev (C) 10/6/98
ª Subwoofer Pre-Out: Connect
this jack to the line level input of a
powered subwoofer. If an external
subwoofer amplifier is used, connect
this jack to the subwoofer amplifier
input.
‚ Front: Connect these terminals
to the front left/right speakers.
⁄ Center: Connect these terminals
to the center speaker.
¤ Surround: Connect these
terminals to the surround speakers.
‹ Unswitched AC Outlet: This
outlet may be used to power any AC
device. The power will remain on at
this outlet regardless of whether the
AVR65 is on or off.
NOTE: The power consumption of
the device plugged into each of
these outlets should not exceed
100 watts.
› Switched AC Outlet: This outlet
may be used to power any device
that you wish to have turn on when
the unit is turned on with the
System
Power Control switch 2.
fi Power Cable: Connect the AC
plug to a non-switched AC wall
output
fl Video 2 Inputs: Connect these
jacks to the audio and video outputs
of a TV Tuner, Cable TV converter
box, satellite receiver or any other
audio/video source.
‡ TV Monitor Video Output:
Connect this jack to the standard
(composite) video input of a TV
monitor or video projector to view
the on-screen menus and the
output of any standard video source
selected by the receiver’s video
switcher.
° Coaxial Digital Input: Connect
the coax digital output from a DVD
player, HDTV receiver, LV player or
CD player to this jack. The signal may
be either a Dolby Digital (AC-3) sig-
nal, DTS signal or a standard PCM
digital source.
· Optical Digital Input: Connect
the optical digital output from a DVD
player, HDTV receiver, LV player or
CD player to this jack. The signal
may be either a Dolby Digital (AC-3)
signal, a DTS signal or a standard
PCM digital source.
a Remote IR In: If the AVR65’s front
panel IR sensor is blocked due to
cabinet doors or other obstructions,
an external IR sensor may be used.
Connect the output of the sensor to
this jack.
b Remote IR Out: This connection
permits the IR sensor in the receiver
to serve other remote controlled
devices. Connect this jack to the “IR
IN” jack on Harman Kardon or other
compatible equipment.
c Multi: Connect the output of
an IR sensor in a remote room to
this jack to operate the AVR65’s
multiroom control system.
d Multiroom Audio Outputs:
Connect these jacks to the inputs of
an optional audio power amplifier so
that the input selected by the multi-
room control system will be heard in
a remote room.
e Tape Monitor In: Connect these
jacks to the PLAY/OUT jacks of an
audio recorder.
f Tape Monitor Out: Connect
these jacks to the RECORD/INPUT
jacks of an audio recorder.