Harbor Freight Tools Pacific Hydrostar 1-1/2" Gasoline Powered Clear Water Pump 68328 - Manual (Page 14)

Page 12 For Pump technical questions, please call 1-800-444-3353. Item 68328
For Engine technical questions, please call 1-800-520-0882.
Checking and Filling Fuel
WARNING! TO PREVENT SERIOUS
INjURY FROM FIRE:
Fill the fuel tank in a well-ventilated area away
from ignition sources. If the engine is hot from
use, shut the engine off and wait for it to cool
before adding fuel. Do not smoke.
1. Clean the Fuel Cap and the area around it.
2. Unscrew and remove the Fuel Cap.
3. If needed, fill the Fuel Tank to up to the top
of the Fuel Level marker on the fuel filter with
87 octane or higher unleaded gasoline.
Note: Do not use gasoline containing more than
10% ethanol (E10). Do not use E85 ethanol.
Note: Do not use gasoline that has been stored in
a metal fuel container or a dirty fuel container. It
can cause particles to enter the carburetor, affecting
engine performance and/or causing damage.
4. Then replace the Fuel Cap.
5. Wipe up any spilled fuel and allow excess to evaporate
before starting engine. To prevent FIRE, do not start
the engine while the smell of fuel hangs in the air.
Engine Oil Change
CAUTION! Oil is very hot during operation and can
cause burns. Wait for engine to cool before changing oil.
1. Make sure the engine is stopped and is level.
2. Close the Fuel Valve.
3. Place a drain pan (not included) underneath
the crankcase’s drain plug.
4. Remove the drain plug and, if possible,
tilt the crankcase slightly to help drain
the oil out. Recycle used oil.
5. Replace the drain plug and tighten it.
6. Clean the top of the Dipstick and the area around it.
Remove the Dipstick by threading it counterclockwise,
and wipe it off with a clean lint free rag.
7.
Full level
Full level
Add the appropriate type of oil until the oil level is at
the full level. SAE 10W-30 oil is recommended for
general use.
The SAE Viscosity Grade chart shows other
viscosities to use in different average temperatures.
10W-30
30
5W-30
-20 0 20 40 60 80 100°F
SAE Viscosity Grades
Average outdoor temperature
8. Thread the dipstick back in clockwise.
CAUTION! Do not run the engine with too little
oil. The engine will be permanently damaged.
Air Filter Element Maintenance
1. To remove the air filter cover, unthread the threaded
knobs and remove the cover and the air filter elements
and check for dirt. Clean or replace as described below.
2.
Filter Cover
Filter
Gasket
Threaded
Knobs
Cleaning:
• Foam filter element:
Wash the element in warm water and mild
detergent several times. Rinse. Squeeze
out excess water and allow it to dry
completely. Soak the filter in lightweight oil
briefly, then squeeze out the excess oil.
3. Install the new filter or the cleaned filter.
Secure the Air Cleaner Cover before use.