Hunter Fan 44459 - Manual (Page 19)

■ Your thermostat can be programmed for weekdays and for
Saturday and Sunday. Use the Programming steps below to
enter or revise programs to match your Personal Program
Schedule. The same steps are used when entering programs
for the first time, or revising programs entered during Auto
Programming.
■ When batteries are first installed, the thermostat has all 4 programs
set for 68°F (20°C) in Heat mode and 78°F (26°C) in Cool mode.
NOTE: There are no energy saving time or temperature
settings until the thermostat is Auto Programmed or
Manually Programmed.
■ Familiarize yourself with Manual Programming, so that you can
easily modify your programs as your comfort needs change. The
example below demonstrates the Manual Programming method.
NOTE: 1) The program time can be set in 10 minute
increments, and remains the same for both Heat
and Cool programs.
2) The program temperature can be set in increments
of 1°F (1°C).
3) The Heat setpoint can not be set higher than the
Cool setpoint, and the Cool setpoint can not be set
lower than the Heat setpoint.
4) If the system selector is in AUTO mode, the current
operating mode will be used for programming.
5) After 15 seconds without a key press, the
thermostat will return to normal display mode.
6) When setting the program time, note the AM / PM
indicator.
7) With the Auto Recovery feature enabled, you do not
need to set your comfort program times early. Auto
Recovery will determine how early to turn your
system on, so that the room is comfortable at the
program time.
Manual Programming
Weekday Programming
Step 1
■ Slide System Selector Switch to HEAT or COOL to program the
corresponding system. -- -- -- --
COOL OFF HEAT AUTO
NOTE: If the system selector is in the OFF position, no programming is permitted. The LCD
display will show only dashes when the program key is pressed.
PAGE 19
B99A p1-19 2/7/03 9:58 AM Page 19