Hitachi VM-H71A - Manual (Page 51)

Advanced Techniques
51
It is necessary to program the edit remote control code to match the VCR
before starting editing.
1. Turn the VCR on.
2. Aim the remote control at the infrared receiver on the VCR and press
the VCR SET button on the remote control and hold it, then press the
button corresponding to the VCR's maker code. For example, if you ave a
RCA VCR, press the VCR SET button and hold it, then press the
DISPLAY button. To check whether the remote control code matches that
of your VCR or not, point the remote control at the infrared receiver on the
VCR and press the VCR SET button and hold it. If the remote control code
has been set, the VCR channel is counted up automatically.
Note: Your VCR should have an infrared remote control.
Note: If the channel on the VCR does not change with the above operation,
you need to switch the remote control code of your VCR. Refer to the VCR's
instruction manual. If the channel still does not change after you have
changed the VCR's remote control code, the edit remote control cannot
operate your VCR.
VCR Brands Press VCR SET and This Button
Hitachi REVERSE
Sony PROGRAM
Panasonic FORWARD
Toshiba IN
Mitsubishi COPY START
Sanyo OUT
Sharp
NEC
JVC
Akai A/V DUB
Gold Star
PHILIPS
RCA DISPLAY
Zenith COUNTER RESET
Magnavox TITLE ON/OFF
Note: The remote control code is held in memory until it is changed or the
batteries are replaced.