Hitachi 42PD8800TA - Manual (Page 21)

20
ENGLISH
BASIC OPERATION (continued)
Input Switching to TV/AV1~5, HDMI, and RGB
By pressing Input Select button, you can switch the input.
To watch actual broadcast, press Input Select button on the control panel,
the numeric buttons or Channel Up/Down button on the remote control.
To display the image outputting from the external equipments
connected to each terminal (AV1~5, HDMI 1, 2, and RGB), select
corresponding mode.
1. Press Input Select buttons on the remote control.
2. The Input modes can be also switched by using Input Select button
on the control panel.
Each time this button is pressed, the screen displays corresponding
mode by following order.
TV AV1 AV2 AV3 AV4
AV5 HDMI 1 HDMI 2 RGB
3. To directly go back to TV mode, pressing channel Up/Down buttons on
either remote control or the control panel.
Also, you can use the numeric buttons on the remote control.
Input Signal Screen Display
The input signal status can be displayed on the screen by
pressing the
+ button of the remote control.
The display will go out in approximately 6 seconds.
Channel Up button
Channel Down button
Input Select
P
P
SD MEMORY
CARD
PUSH-EJECT
OK
PH35814
Input Select buttons
Channel
Up/Down button
1
ABCDE
-- -- Min.
-- -- : -- --
OFF
Off-timer
On-timer
TV position
Name
Sound mode TV
AV1
Composite
-- -- Min.
-- -- : -- --
OFF
Off-timer
On-timer
Input mode
Signal mode VIDEO
RGB
H : 48.4kHz
V : 60.1 Hz
-- -- Min.
-- -- : -- --
OFF
Off-timer
On-timer
Input mode
Input horizontal frequency
Input vertical frequency
RGB
RECALL
button